mbstring extension must be loaded in order to run mPDF
dellemc
Table of Contents
Dell EMC SmartFabric
Connect to a switch using ssh.
Navigation
| Paged output | Expand by one line | Return |
|---|---|---|
| Expand by one screen (25 lines?) | Space | |
| Cancel paging | Q | |
| Help and completion | Complete a prompt | Tab |
| Show all possible commands and subcommands | ? |
Frequently Used Commands
| Mode | Effect | Example | ||
|---|---|---|---|---|
| Main | Show complete config | show running-config |
||
| Show VLAN setup | show vlan |
|||
| Enter config mode | conf t |
|||
| Config | Change settings for this interface | e.g. int vlan 23 int gigabit 1/23 This will put you in the interface config mode |
||
| Interface Config | VLAN | Add ports to VLAN | untagged Gi 1/38 or tagged Gi 1/38 |
|
| Remove ports from VLAN | no untagged Gi 1/38 or no tagged Gi 1/38 |
|||
| Port | Shutdown port (sometimes necessary for further configuration) | shutdown |
||
| Reset port config | no portmode hybrid no switchport shutdown Refer to show running-config to see all the options on a port! |
|||
| Allow port to use tagged VLANs | portmode hybrid switchport no shutdown Then, continue to edit the VLANs and add the port |
|||
| Exit interface config mode | exit |
|||
| End config mode | end |
|||
| Main | Make persistent/write config | wr copy running-config startup-config |
||
Public Key Authentication
Authenticate with OS9
conf t ip ssh rsa-authentication enable exit start shell # (login as admin) echo "$PUBKEY" > /f10/flash/id_rsa.pub exit ip ssh rsa-authentication my-authorized-keys flash://id_rsa.pub wr
Authenticate with OS10
conf t
username admin sshkey "$PUBKEY"
ex
wr
dellemc.txt · Last modified: by wolfo